18el (9H/9V) X-POL 144MHz LFA Yagi H Frame
-A 2.9m x 2.9m H frame for use with the 9el 144MHz X-POL LFA Yagi antennas
IMPORTANT NOTES: despite what you may see from other manufacturers, it is not best practice to have any part of the vertical sections of the H frame conductive on an X-POL intended H-Frame. Pattern distortion WILL occur and this will impede the ability of your system to receive weak signals.
Should you be looking to work via the moon (EME) or just work some serious DX via MS (Meteor Scatter) or just pack a punch! The InnovAntennas H-shaped stacking frame allows you to do just that. Combining the power of 4 X-pol (crossed) antennas in one setup carries with it a lot of benefits including the performance of a much bigger single Yagi within a relatively small package.
Our H frame is designed to allow most common Elevation rotator fittings (such as Yaesu G5500 or SPID as an example, quote your rotator type at time of ordering) although we can custom-make any H frame to suit your particular rotor requirements. All our X-POL H frames have non-conductive vertical sections to ensure absolute minimal pattern distortion as a result. this means you will maintain your ability to hear super-weak signals even with the smallest system in the air!
All supplied hardware is Marine grade stainless steel and the H frame is supplied with 4 specifically designed boom to mast brackets to suit your antennas boom.
- Marine grade stainless steel fittings*
- 4 x Specifically designed boom to mast brackets
- Mill finished for highest levels of accuracy
- Simple and easy construction
- Stack Frame size 2.9m V x 2.9m H
Notes on the designs of our H frames
The standard supplied sizes for our H frames will ensure the lowest noise and most quiet patterns with absolute minimum side lobes. These stacking positions do alter from those specified on the specific antenna page on our site. The sizes presented on the individual antenna pages reflect DL6WU calculated spacing (with minor adjustments) which represented industry standards and allows for easy comparison. However, our frames are arranged to allow our antennas to perform in the way they were designed. If you require this or any other wider/larger spacing, we will be happy to discuss your requirement with you and provide a solution that suits you.
Should any customer require another configuration, we will provide the H frame to suit.
Manufactured the right way, not the cheapest way!
*Where possible marine grade stainless steel components are used.